Wyse 9650XE Specifications download pdf (Page 3)

iii

Caution

Changes or modifications not covered in this manual must be approved in writing by the

manufacturer’s Regulatory Engineering department. Changes or modifications made without

written approval may void the user’s authority to operate the equipment.

Thin Client Requirements Compliance

FCC Compliance

The Models 9450XE, 9455XL, 9650XE, Model J400, Product 941GXL, Model x150SE, Product 9150SE, SX0,

and VX0 Thin Clients meet Class B requirements.

IEC/EN Compliance

The Models 9450XE, 9455XL, 9650XE, Model J400, Product 941GXL, Model x150SE, Product 9150SE, SX0,

and VX0 Thin Clients meet Class B requirements.

Canadian DOC Notices

Refer to the previous section, "Thin Client Requirements Compliance," to find out to which Thin Client model

each of the statements below refers.

Class A

This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out

in the Radio Interference Regulations of the Canadian Department of Communications.

Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables aux

appareils numériques de la classe A prescrites dans le Réglement sur le brouillage radioélectrique édicté par le

Ministère des Communications du Canada.

Class B

This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set out

in the Radio Interference Regulations of the Canadian Department of Communications.

Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables aux

appareils numériques de la classe B prescrites dans le Réglement sur le brouillage radioélectrique édicté par le

Ministère des Communications du Canada.

IEC/EN Notice

These products conform to the requirements of IEC950 and EN60950.

These products conform to requirements of EN55022 for Class A equipment or EN55022 for Class B equipment

(refer to "Thin Client Requirements Compliance").

Cable Notice

The use of shielded I/O cables is required when connecting this equipment to any and all optional peripheral or

host devices. Failure to do so may cause interference and violate FCC and international regulations for

electromagnetic interference.

Noise Suppressor

A noise suppressor (ferrite bead) must be installed on the network cable of your Thin Client. This installation is

necessary to maintain compliance with U.S. FCC B limits and European CISPR B EN55022 Class B limits. The

noise suppressor is supplied by the manufacturer and is packed in your Thin Client shipping carton.

1 2 3 4 5 6 7 8 ... 73 74

No comments

Wyse 9650XE Specifications Page 3