Wyse 4GB Flash upgrade kit Installation Guide download pdf (Page 7)

2 Installing C Class Flash

This chapter contains information for C30LE, C50LE, C90LE, C90LEW, and C90LE7

cloud client users who must install new flash.

Requirements

• Small Phillips screwdriver

• Needle-nose pliers

• (Optional) Plastic alignment tools or equivalent for prying

Warning

Flash modules may be susceptible to damage by Electro-Static Discharge

(ESD). All industry-standard cautions should be followed to avoid ESD.

Before you remove or install a module, touch any metal part of the chassis

and keep that contact with the chassis during the installation process.

Procedures

Caution

Follow all precautions listed in the Quick-Start Guide that came with your

cloud client for disconnecting and reconnecting the cloud client.

1. Perform a proper shutdown of the cloud client by closing all files and ending your

session, and then press the power button to turn off the cloud client.

2. Unplug the power cord and power adapter, remove all of the cables from the rear of the

cloud client, and then detach any support feet.

3. Position the cloud client horizontally, remove the screw from the back of the cloud

client using a small Phillips screwdriver, and then use a plastic alignment tool to pry

and loosen the top cover as shown in Figure 1.

Figure 1 Removing the top cover

1 2 3 4 5 6 7 8 9 10 11 12 ... 21 22

No comments

Wyse 4GB Flash upgrade kit Installation Guide Page 7